Motorcycle
Battery Charging Information
Conventional
or Lead Acid Type Motorcycle Batteries
1) Remove the packing &
yellow stoppers from the top of the battery. Remove the cap
from the end of the breather nipple located at the top on
the side of the battery.
2) Fill each of the holes in the top of the
battery with battery acid up to the upper level mark on the
front of the battery (do not replace the yellow stoppers yet)
3) Charge the battery for at least 4 to 6 hours (preferably overnight) with
a Motorcycle
Battery Charger
4) After charging, disconnect the battery
from the charger & leave to settle for 1 hour
5) Re check the battery acid level (make
sure it is up to the upper level mark) & top up the acid
levels if required
6) Securely replace the yellow stoppers into
the holes in the top of the battery
7) The battery is now filled & charged
& ready for use (when connecting to a motorbike/scooter,
always connect the positive (+) terminal first)
Top of Page
Maintenance
Free or Sealed Type Motorbike Batteries
1) Remove the packing &
remove the tin foil strip from the top of the battery. Remove
the battery acid pack(s) from the plastic bag but DO
NOT remove the foil from the top of the acid packs.
2) Invert the acid pack into the top of the
battery so the foil covered tops of the acid packs are covering
the holes in the top of the battery. Press the acid pack down
firmly into the holes in the battery (a series of spikes inside
the battery holes will pierce the foil & let the acid
out). Gently tap the acid packs until all the acid has gone
into the battery. Sealed batteries come with 1 or 2 acid packs,
use all the acid that comes with the battery as this provides
the required amount to fill the battery.
3) Leave the battery to settle for 1 hour
4) Place the plastic strip into the holes
on the top of the battery & press firmly into place until
the plastic strip fits flush with the top of the battery.
5) Charge the battery for at least 4 to 6 hours (preferably overnight) with
a Motorcycle
Battery Charger
6) Disconnect the battery from the battery
charger.
7) The battery is now filled & charged
& ready for use (when connecting to a motorbike/scooter,
always connect the positive (+) terminal first)
Top of Page
Gel Filled Motorcycle
Batteries
1) Remove the battery from
its packing
2) Charge the battery for at least 4 to 6 hours (preferably overnight) with
a Motorcycle
Battery Charger
3) Disconnect the battery from the battery
charger
4) The battery is now charged & ready
for use (when connecting to a motorbike/scooter, always connect
the positive (+) terminal first)
Top of Page |
